Double Sided Textured PEI Powder Coated Spring Steel Sheet for Prusa i3 MK3 MK3S

Description

Description:
Size:
241 x 252mm
Package: 1piece PEI powder sheet for
for Prusa i3 MK2.5S mk3 MK3S 3D printer.
Double-sided Textured PEI Spring Steel Sheet for 3D printers
This will be an incredible product ,It allows you to experience unparalleled happiness when you pick up your pieces.
Advantages:
No more 3M Masking tape
No more glue stic
No more ABS juice
No more PEI sheet replacement
Easy to print
Easy to remove by bending and popping it off
Easy to maintain
Double-sided
Lower runing cost  especially for printing farm
Genuine PEI powder coating
Hardened steel spring sheet never diforming
Possible to adding ABL  for some low-cost printers
*Make adding inductive Z-probe possible
Note:
*The item is large in size and heavy in weight. Therefore, the transportation fee is very high. Please consider buying it again. Because we do not accept no reason to refund.
The texture board may have a small flaw in the production process. We are all manual screenings to ensure that there are no major flaws. But there are some small flaws that cannot be avoided. If you do not accept, please do not buy. Thank you for your understanding.
*Due to the size of the product is huge. In order to control the strength of the bend. We maintain a relatively thin thickness. So it is not flat when it is not magnetically adsorbed. When it is placed in a magnetic bed, it will be magnetically adsorbed so that it will automatically flatten.
Maintenance:
Wipe the print surface before and after a print with isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength. As with any build surface, make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface. If printing PETG, TPU, TPE, and RYNO, make sure the bed is heated BEFORE attempting to remove the print from the bed.
​​​​
Attention:
*It is possible to mount our kits on a larger bed, just be aware that you will have a reduced printing area. It is also possible to mount our kits on slightly smaller beds; you can carefully trim the Magnetic Base, but the Flexi Plate will stick over your edges, be sure that there are no obstructions such as vertical frame elements, and it is advisable not to have more than 10mms overhang per side to avoid warping. we are not responsible for mistaken order sizes.
HOW TO USE IT?
You also need a magnetic base add-on, which is sticked onto the Heated bed via 3M adhesive backing
then Put the Powder coated spring steel plate on the magnetci base.